Inspection and maintenance of insulating clothing before and after use
1. Although the fire insulation clothing has good flame retardant properties, it is impossible to protect people under all conditions. When working in close proximity to the flame, it is necessary to wear a respirator, to avoid direct contact with the flame and melted metal as much as possible, and to equip it with appropriate accessories when used in conditions of chemical and radioactive damage.
2. Fire insulation clothing should be carefully checked for damage before use.
3. When entering the job site, it must be equipped and fully dressed. Fasten all closures to ensure that the garment is well sealed.
4. The hood that enters the job site can protect the original steel helmet at the same time, and the steel helmet does not need to be taken off when used, and the fixed belts at both ends of the hood are hung on the triangular ring of the hood surface through the two armpits when used.
5. After use, use a brush dipped in neutral detergent liquid, scrub the residual dirt on the surface, and then rinse it with water, it is strictly forbidden to soak and hammer with water.
6. Complete sets of firefighting insulating clothing must be kept dry and stored in storage bags for ready use.
In the process of maintaining thermal insulation clothing, the following points need to be noted:
1. Fire insulation clothing has the performance of flame retardant and heat insulation, but it cannot prevent all adverse situations, and when approaching the high temperature fire source, direct contact with flames or melted metal should be avoided as much as possible. In the case of chemical gases or radioactive injuries, appropriate accessories and positive pressure respirators are required.
2. The storage place of the heat insulation clothing should be dry and ventilated, and it should be kept away from high temperature sources, open flames and acid chemical solvents, and the composite layer should be prevented from falling off after being damp.
3. Before using the heat insulation clothing, you should do a good job of inspection to see if the heat insulation clothing is damaged.
4. For the heat-insulating clothing after use, a soft brush should be dipped in neutral detergent to scrub the residual dirt on the surface, and then rinsed with clean water, and then the rinsed heat-insulating clothing should be placed in a ventilated place to dry, and put back to the corresponding storage place. Remember, do not blister the garment and do not hammer it.
5. When storing the heat-insulating clothing, you should try to choose hanging, and try not to face the heat-insulating clothing, so as not to fold and damage the clothes many times and affect its protective performance.
6. The heat insulation clothing should be checked and maintained regularly, the frequency is once a week, check whether the aluminum foil is damaged, and clean up the oil stain.
7. The warranty period of fire insulation clothing is one year under the storage conditions.
